22-29 No-Flow Low Speed [Hz] 22-24 No-Flow Delay 22-20 Low Power Auto Set-up Q7-6 Flow Compensation 22-90 Flow at Rated Speed
22-40 Minimum Run Time 22-20 Low Power Auto Set-up 22-22 Low Speed Detection 22-80 Flow Compensation Q7-7 Special Ramps
22-41 Minimum Sleep Time 22-40 Minimum Run Time 22-28 No-Flow Low Speed [RPM] 22-81 Square-linear Curve Approxi-
mation
3-84 Initial Ramp Time
22-42 Wake-up Speed [RPM] 22-41 Minimum Sleep Time 22-29 No-Flow Low Speed [Hz] 22-82 Work Point Calculation 3-88 Final Ramp Time
22-43 Wake-up Speed [Hz] 22-42 Wake-up Speed [RPM] 22-40 Minimum Run Time 22-83 Speed at No-Flow [RPM] 3-85 Check Valve Ramp Time
22-44 Wake-up Ref./FB Difference 22-43 Wake-up Speed [Hz] 22-41 Minimum Sleep Time 22-84 Speed at No-Flow [Hz] 3-86 Check Valve Ramp End Speed
[RPM]
22-45 Setpoint Boost 22-44 Wake-up Ref./FB Difference 22-42 Wake-up Speed [RPM] 22-85 Speed at Design Point [RPM] 3-87 Check Valve Ramp End Speed
[HZ]
22-46 Maximum Boost Time 22-45 Setpoint Boost 22-43 Wake-up Speed [Hz] 22-86 Speed at Design Point [Hz]
Q7-51 Low Power
22-46 Maximum Boost Time 22-44 Wake-up Ref./FB Difference 22-87 Pressure at No-Flow Speed
22-21 Low Power Detection
Q7-52 Low Speed/Power
22-45 Setpoint Boost 22-88 Pressure at Rated Speed
22-23 No-Flow Function 22-21 Low Power Detection 22-46 Maximum Boost Time 22-89 Flow at Design Point
Table 5.3
About Adjustable Frequency ...
VLT
®
AQUA Drive
Instruction Manual
5-6 MG20M922 - VLT
®
is a registered Danfoss trademark
5
5
To Next Page
Loading...
Need help?
General