EN 61000-4-2, EN 61000-4-3, EN 61000-4-4, EN 61000-4-5, EN 61000-4-6
See section on special conditions
Control card performance
Scan interval 5 ms
Control card, USB serial communication
USB standard 1.1 (Full speed)
USB plug USB type B “device” plug
CAUTION
Connection to PC is carried out via a standard host/device USB cable.
The USB connection is galvanically isolated from the supply voltage (PELV) and other high-voltage terminals.
The USB connection is not galvanically isolated from ground protection. Only use an isolated laptop/PC as the connection to
the USB connector on an VLT AQUA Drive or an isolated USB cable/drive.
Specifications
VLT
®
AQUA Drive
Instruction Manual
10-16 MG20M922 - VLT
®
is a registered Danfoss trademark
10
10
To Next Page
Loading...
