Digital input............................................................................................ 67
Digital inputs.......................................................................................... 90
Digital output......................................................................................... 92
Dimension............................................................................................... 15
Discharge time...................................................................................... 20
Disconnect switch......................................................................... 51, 52
Distortion................................................................................................... 6
E
ELCB relays.............................................................................................. 37
Electrical installation.................................................................... 42, 44
Electromechanic brake....................................................................... 46
EMC............................................................................................................ 51
EMC-compliant installation.............................................................. 35
Enclosure................................................................................................. 15
External alarm reset............................................................................. 63
External fan supply.............................................................................. 39
F
Factory-installed brake chopper option...................................... 38
Fan.............................................................................................................. 39
Fault log................................................................................................... 53
Fault messages - active lter............................................................ 77
Feedback.................................................................................... 47, 51, 70
F-frame option....................................................................................... 49
Filter capacitors..................................................................................... 37
Final set-up and test............................................................................ 48
Fourier series analysis......................................................................... 15
Full load current.................................................................................... 21
Fuse..................................................................................................... 35, 69
Fuse tables.............................................................................................. 98
Fuses............................................................................................ 51, 79, 97
Fusing....................................................................................................... 51
G
Grid conditions...................................................................................... 94
Ground connections............................................................................ 51
Ground wire............................................................................................ 51
Grounding.......................................................................... 36, 37, 51, 52
H
Hand on.................................................................................................... 54
Harmonic mitigation performance................................................ 94
Harmonics
Analysis................................................................................................ 15
Harmonics........................................................................ 6, 15, 16, 17
distortion............................................................................................ 15
Overload prevention....................................................................... 15
Voltage harmonics........................................................................... 16
Heater....................................................................................................... 49
Heatsink................................................................................................... 70
High voltage........................................................................................... 51
I
IEC emergency stop, Pilz safety relay............................................ 50
Initialisation............................................................................................ 55
Input polarity of control terminals, PNP....................................... 45
Input power....................................................................... 20, 51, 65, 79
Input signal............................................................................................. 47
Input terminal........................................................................................ 66
Input voltage................................................................................... 52, 65
Inputs
Input terminal............................................................................ 47, 51
Installation....................................................................................... 51, 52
Insulation resistance monitor.......................................................... 50
Intermediate circuit............................................................................. 66
IT line power........................................................................................... 37
L
Leakage current (>3.5 mA)................................................................ 36
Lifting........................................................................................................ 24
Line power supply (L1, L2, L3).......................................................... 90
Local control........................................................................................... 54
Local control panel (LCP)................................................................... 52
M
Main menu.............................................................................................. 53
Mains
input..................................................................................................... 31
terminal............................................................................................... 47
voltage................................................................................................. 53
Supply.................................................................................................. 15
Manual initialisation............................................................................ 55
Manual motor starter.......................................................................... 50
MCT 10...................................................................................................... 53
Mechanical brake control.................................................................. 46
Mechanical dimension....................................................................... 86
Menu key................................................................................................. 53
Menu structure...................................................................................... 53
Index
VLT
®
AQUA Drive FC 202 Low Harmonic Drive
116 Danfoss A/S © 10/2015 All rights reserved. MG21B322
To Next Page
Loading...
Need help?
General