Danfoss vlt aqua Design Guide

4How to Order
4.1 Ordering form
4.1.1 Drive Configurator
It is possible to design a VLT AQUA adjustable frequency drive according to the application requirements by using the ordering number system.
For the VLT AQUA, you can order standard drives and drives with integral options by sending a type code string describing the product to the Danfoss
sales office, for example.:
FC-202P18KT4E21H1XGCXXXSXXXXAGBKCXXXXDX
The meaning of the characters in the string can be located in the pages containing the ordering numbers in the chapter
How to Select Your VLT . In the
example above, a Profibus LON works option and a General purpose I/O option is included in the drive.
Ordering numbers for VLT AQUA Drive standard variants can also be located in the chapter
How to Select Your VLT .
Use the Internet-based drive configurator to configure the right drive for the right application and generate the type code string. The drive configurator
will automatically generate an eight-digit sales number to be delivered to your local sales office.
Furthermore, you can establish a project list with several products and send it to a Danfoss sales representative.
The drive configurator can be found on the global Internet site: www.danfoss.com/drives.
VLT
®
AQUA Drive Design Guide 4 How to Order
MG.20.N5.22 - VLT
®
is a registered Danfoss trademark 4-1
4

Danfoss vlt aqua Specifications

General

Supply Voltage	200-240V, 380-500V, 525-600V
Enclosure	IP20
Features	Energy optimization
Approvals	CE, UL, cUL
Input Voltage Range	200-240V, 380-500V, 525-600V
Output Voltage Range	0 to supply voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication Interfaces	PROFIBUS
Cooling Method	Air-cooled