3.7.4 Floor Mounting - Pedestal Installation IP21 (NEMA1) and IP54 (NEMA12)
Install the pedestal on the floor. Fixing holes are to be drilled according
to this figure:
Figure 3.34: Drill master for fixing holes in floor.
Mount the drive on the pedestal and using the enclosed bolts, attach it
to the pedestal, as shown in the illustration.
Figure 3.35: Mounting the drive to the pedestal
NOTE!
Please see the
Pedestal Kit Instruction Manual, 175R5642
, for further information.
3 VLT AQUA Selection VLT
®
AQUA Drive Design Guide
3-52
MG.20.N5.22 - VLT
®
is a registered Danfoss trademark
3
To Next Page
Loading...
