Danfoss vlt aqua Operating Instructions

1.1.3 Software Version and Approvals
VLT AQUA Low Harmonic Drive
Software version: 1.33
This manual can be used with all VLT AQUA Low Harmonic Drive frequency converters with software version 1.33.
The software version number can be found in parameter 15-43 on the drive LCP.
NB!
The VLT AQUA Low Harmonic Drive has two different LCPs, one for the frequency converter (to the right) and one for the active filter
(to the left). Each LCP controls only the unit it is connected to and there is no communication between the two LCPs
1.1.4 Symbols
Symbols used in these Operating Instructions.
NB!
Indicates something to be noted by the reader.
Indicates a general warning.
Indicates a high-voltage warning.
*
Indicates default setting
1 How to Read these Operating Instructions
VLT AQUA Low Harmonic Drive Operating In-
structions
6 MG.20.T1.02 - VLT
®
is a registered Danfoss trademark
1

Danfoss vlt aqua Specifications

General

Supply Voltage	200-240V, 380-500V, 525-600V
Enclosure	IP20
Features	Energy optimization
Approvals	CE, UL, cUL
Input Voltage Range	200-240V, 380-500V, 525-600V
Output Voltage Range	0 to supply voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication Interfaces	PROFIBUS
Cooling Method	Air-cooled