Danfoss vlt aqua User Manual

22-83 Speed at No-Flow [RPM]
Range: Function:
Application
dependent*
[Application dependant]
22-84 Speed at No-Flow [Hz]
Range: Function:
Application
dependent*
[Application dependant]
22-85 Speed at Design Point [RPM]
Range: Function:
Application
dependent*
[Application dependant]
22-86 Speed at Design Point [Hz]
Range: Function:
Application
dependent*
[Application dependant]
22-87 Pressure at No-Flow Speed
Range: Function:
0.000 N/A* [Application dependant] Enter the pressure H
MIN
corresponding to speed at no-flow in reference/feedback units.
22-88 Pressure at Rated Speed
Range: Function:
999999.999
N/A*
[Application dependant] Enter the value corresponding to the pressure at rated speed in reference/feedback units. This value
can be defined using the pump datasheet.
22-90 Flow at Rated Speed
Range: Function:
0.000 N/A* [0.000 - 999999.999 N/A] Enter the value corresponding to flow at rated speed. This value can be defined using the pump
datasheet.
5 How to program the adjustable frequency
drive
VLT AQUA High Power Instruction Manual
5-44 MG.20.P3.22 - VLT
®
is a registered Danfoss trademark
5

Danfoss vlt aqua Specifications

General

Supply Voltage	200-240V, 380-500V, 525-600V
Enclosure	IP20
Features	Energy optimization
Approvals	CE, UL, cUL
Input Voltage Range	200-240V, 380-500V, 525-600V
Output Voltage Range	0 to supply voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication Interfaces	PROFIBUS
Cooling Method	Air-cooled