The number of the active set-up (selected as the active set-up in par. 0-10) is shown. When programming in a set-up other than the active set-up, the
number of the set-up being programmed appears to the right in brackets.
Middle section (b)
shows up to 5 variables with related unit, regardless of status. In case of an alarm/warning, the warning is shown instead of the variables.
It is possible to toggle between three status readout displays by pressing the [Status] key.
Operating variables with different formatting are shown in each status screen - see below.
Several values or measurements can be linked to each of the displayed operating variables. The values/measurements to be displayed can be defined
via par. 0-20, 0-21, 0-22, 0-23, and 0-24, which can be accessed via [QUICK MENU], "Q3 Function Set-ups", "Q3-1 General Settings", "Q3-11 Display
Settings".
Each value/measurement readout parameter selected in par. 0-20 to par. 0-24 has its own scale and number of digits after a possible decimal point.
Larger numeric values are displayed with few digits after the decimal point.
Ex.: Current readout
5.25 A; 15.2 A 105 A.
Status display I
This readout state is standard after start-up or initialization.
Use [INFO] to obtain information about the value/measurement linked to
the displayed operating variables (1.1, 1.2, 1.3, 2 and 3).
See the operating variables shown in the display in this illustration. 1.1,
1.2 and 1.3 are shown in small size, while 2 and 3 are shown in medium
size.
1
3
0
B
P
0
4
1
.
1
0
1.1
1.3
2
1.2
3
4 How to operate the adjustable frequency
drive
VLT AQUA High Power Instruction Manual
4-2
MG.20.P3.22 - VLT
®
is a registered Danfoss trademark
4
To Next Page
Loading...
