What to do if Danfoss VLT AutomationDrive FC 303 motor will not brake?
If the Danfoss DC Drives motor will not brake, it may be due to incorrect settings in the brake parameters or ramp-down times that are too short. Check parameter group 2-0* DC brake and 3-0* Reference limits.
General| Category | DC Drives |
|---|---|
| Output Voltage | 0 to Input Voltage |
| Power Range | 0.25 kW |
| Control Method | VVCplus, Flux Vector Control |
| Communication Protocols | Ethernet/IP, Modbus RTU, Profibus, CANopen, DeviceNet |
| Enclosure Type | IP20, IP21 |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Short Circuit, Ground Fault, Overtemperature |
| Ambient Temperature | -10 to +50 °C |
| Storage Temperature | -25°C to 70°C |
| Relative Humidity | 5-95% non-condensing |
| Altitude | Up to 1000 m without derating |
To Next Page