Danfoss VLT Flow Drive FC 111 - Page 128

[71]
SL Time-out 4
[72]
SL Time-out 5
[73]
SL Time-out 6
[74]
SL Time-out 7
[81]
Dry Pump
[82]
End of Curve
[83]
Broken Belt
13-52 SL Controller Action
Default value: [0] Disabled
Parameter type: Option
2-setup: 1 setup
Conversion index: -
Data type: u_int8
Change during operation: True
Select the action corresponding to the SLC event. Actions are executed when the corresponding event (defined in parameter 13-51
SL Controller Event) is evaluated as True.
Table 232: Option:
[0]
Disabled
This function is not activated.
[1]
No action
No action.
[2]
Select setup 1
Change the active setup (parameter 0-10 Active Set-up) to setup 1.
[3]
Select setup 2
Change the active setup (parameter 0-10 Active Set-up) to setup 2.
[10]
Select preset ref 0
Select preset reference 0.
[11]
Select preset ref 1
Select preset reference 1.
[12]
Select preset ref 2
Select preset reference 2.
[13]
Select preset ref 3
Select preset reference 3.
[14]
Select preset ref 4
Select preset reference 4.
[15]
Select preset ref 5
Select preset reference 5.
[16]
Select preset ref 6
Select preset reference 6.
[17]
Select preset ref 7
Select preset reference 7. If the active preset reference is changed, it merges with other preset
reference commands coming from either the digital inputs or via a fieldbus.
[18]
Select ramp 1
Select ramp 1.
[19]
Select ramp 2
Select ramp 2.
[22]
Run
Issue a start command to the drive.
[23]
Run reverse
Issue a start reverse command to the drive.
[24]
Stop
Issue a stop command to the drive
[25]
Qstop
Issue a quick stop command to the drive.
[26]
DC Brake
Issue a DC stop command to the drive.
[27]
Coast
The drive coasts immediately. All stop commands including the coast command stop the SLC.
AU363928304090en-000101 / 130R0982128 | Danfoss A/S © 2021.07
Parameters
VLT® Flow Drive FC 111
Programming Guide