NOTICE: There is no intent on the part of Data Aire, Inc. to define local codes
or statutes which may supersede common trade practices. The manufacturer
assumes no responsibility for their interpretation. Consult local building codes
and National Electrical Code (NEC) for special installation requirements.
During installation, operation, maintenance or service, individuals may be exposed to certain
components or conditions including, but not limited to: refrigerants, oils, and materials under
pressure, rotating components, and both high and low voltage. Each of these items has the
potential, if misused or handled improperly, to cause bodily injury or death. It is the obligation
and responsibility of operating/service personnel to identify and recognize these inherent
hazards, protect themselves, and proceed safely in completing their tasks. Failure to comply
with any of these requirements could result in serious damage to the equipment and the
property in which it is situated, as well as severe personal injury or death to themselves and
people at the site.
This document is intended for use by owner-authorized operating/service personnel. It is
expected that this individual possesses independent training that will enable them to perform
their assigned tasks properly and safely. It is essential that, prior to performing any task on this
equipment, this individual shall have read and understood this document and any referenced
materials. This individual shall also be familiar with and comply with all applicable
governmental standards and regulations pertaining to the task in question.
This manual contains important safety instructions that should be followed during the
installation and maintenance of Data Aire equipment. Read this manual thoroughly before
attempting to install or operate this unit.
Only qualified personnel should move, install or service this equipment. Adhere to all warnings,
cautions and installation, operating and safety instructions on the unit and in this manual.
Follow all operating and user instructions.
WARNING: Risk of handling heavy and lengthy parts, risk of top-heavy
unit falling over, risk of sharp edges, splinters and exposed fasteners;
can cause personal injury and equipment damage. Cabinet doors and
panels can weigh more than 35lb. (15.9kg) therefore follow relevant
OSHA lifting recommendations and consider using a two-person lift for
safe and comfortable removal and installation of cabinet doors and
panels.
Only properly trained and qualified personnel wearing appropriate safety
headgear, gloves and shoes should attempt to remove or install cabinet
doors and panels.
To Next Page
Loading...
