14
Equipment Handling and Rigging
WARNING: Only properly trained personnel wearing appropriate safety
head- gear, gloves, shoes and glasses should attempt to move the unit,
lift it, remove packaging or prepare the unit for installation.
Door and Rear Panel Removal
Removal of the decorative doors is easily accomplished and may be done when moving
equipment. The door hinge is spring loaded and slides down using the catch, for easy removal
of the doors. Door hinges allow the door to be lift off.
WARNING: When releasing the spring-loaded upped door hinge, be
prepared for the weight of the door. Risk of handling doors can cause
personal injury and equipment damage. Follow relevant OSHA lifting
recommendations and consider using a two-person lift for safe and
comfortable removal and installation of doors. Only properly trained and
qualified personnel wearing appropriate safety headgear, gloves and
shoes should attempt to remove or install doors.
Unlock and open the door by using a flat blade screwdriver or other tool to turn the door latch
90 degrees to unlock the door. Most doors on larger floor mounted units will have a door latch
at the top and bottom of each door. Unplug the dap display connection cables, if needed.
Pull down on the spring-loaded catch to disengage the top of the door, then lift the door up and
off the fixed bottom hinge pin. When re-installing doors, remember to reconnect the dap4
display interface connection cable, if needed.
Figure 1 Typical Upper Spring-Loaded Hinge
To Next Page
Loading...
