To Next Page

To Previous Page

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide 61

IPv4 DHCP

 ON

 OFF

DynamicHostConfigurationProtocol(DHCP)isa

networkfeaturethatassignsIPaddressestodeviceson

thenetwork:

 ONusesDHCPtoassigntheprinterIPaddress.The

IPaddresscanchangewhenyoupoweroffthe

printerandthenpoweritonagain.

 OFFmeansthatyoumustassigntheIPaddressof

theprinteranditwillnotchange(staticIP).Usethis

settingifyournetworkdoesnotsupportDHCP.

Askyournetworkadministratorwhichsettingtouse.

Setting:

IPAddress

ThedefaultIPaddressoftheprinteris192.168.0.141,

andisdispl ayedwhen

theprinterispoweredonforthe

firsttimeorwhenDHCPissettoOn.

IfyoudonotuseDHCP,askyournetworkadministrator

fortheIPaddresstouse.

SubnetMask Thedefaultsubnetmaskoftheprinteris

255.255.255.0.IfyoudonotuseDHCP,askyour

networkadministratorforthesubnetmask.

Gateway Thedefaultgatewayoftheprinteris192.168.0.1.If

youdonotuseDHCP,askyournetworkadministrator

forthesubnetmask.

EffectiveIP TheIPaddresstheprinteruses.

IPv6

AdrsConfig

 Auto

 Manual

MethodtosettheIPaddressifthenetworkusesIPv6.

Setting:

IPAddress Theprinterdoe snothaveandefaultIPv6IPaddress.If

AdrsConfigissettoAutoandtheprinterisnot

connectedtoanetwork,Noneisdisplayed.

PrefixLen Thedefaultprefixlengthis64.

MenuDisplay Settings Function

DataCard SR200 User Manual

Other manuals for DataCard SR200