DataCard SR300

46 Installing the USB Printer Driver
10. SelectthePrintermodelfromthelist.
 IfthisisthefirstSR200orSR300printerinstalledonthisPC,thedefaultprinteris
<name>U1.
 U1istheunitnumber,anditmustmatchtheUSBportyoucreate(refertostep 14)and
thePrintername.
 Usetheselectedprinternameasitisshownor,ifyouplantosharetheprinter,remove
thespaceinthenamesothatitdisplaysasSR‐CPU1.
 IfthisisnottheonlyUSB‐connectedprinteronthisPC,settheunitnumberoftheprinter
now.Referto“InstallingtheStatusMonitor”onpage 55.
11. SelecttheMakethisthedefaultprintercheckboxifyouplantouseonlythisprinterfrom
thisPC.ClickNext
.
12. Powerontheprinter.Continuewiththeinstallation.
ThedefaultprinternameistypicallyU1.Theunitnumberselectedheremustmatchthe
unitnumbersetontheprinter’sLCDpanel.(Re ferto“SettingtheUnitNumber,Printer
Name,andConnection”onpage 59tofindorchangetheprinter’sunitnumbersetting.)
Iftheprinterhasbeenusedbeforethisinstallation,makesurethattheunitnumberand
networknamecorrespond.Forexample,iftheprinterisU2,thenthenetworkprinter
namemustbePRINTER02.Iftheprinterwaspreviouslysettoprintoverthenetwork,
youcanchangethedefaultto
USBatthesametime.