DataCard SR300

SR200 & SR300 Card Printers and LM200 & LM200 Laminators Installation Guide 61
 IftheprinterissettoNetwork,andyouplantoinstalltheprinterwithaUSBconnection,
clickScanPrinterifneeded,andthenchangethevaluetoUSB.
 Ifyouplantoinstalltheprinterwithanetworkconnection,setupthenetworkdetails,
includingwhethertouseIPv4orIPv6,automaticIPaddressing(DHCP)orassigned
addresses,andaddressvaluesifneeded.
10. ClickUpdatetosendthenewinformationtotheprinter.Theunitnumber
andprintername
nowcorrespondintheprinter.Youcanverifyallthe
settingschangedbyviewingthemontheprinterLCDpanel.Refertothe
“UsingtheLCDPanelMenus”sectionoftheUser’sGuide.
11. DisconnecttheUSBcabletoseparatetheprinterfromthePC.Powerofftheprinter.
12. Returnto
step 3toassigntheunitnumberandprinternametothenextprinter,ifmultiple
printersareinstalled.
Youcanuseonlyonemethod(USBornetwork)toconnectaprinter.
IfyouplantouseanySR200orSR300printersfromthisPC,donotuninstalltheStatus
Monitor.