Datacolor 650/600/400 User's Guide Powering Up • 19
3. Turn on the instrument power switch. This is located on the lower right side of
your instrument toward the front.
− When power is applied, all mechanisms are automatically reset.
− The red lights on the status panel will flash briefly.
NOTE
If the instrument power is not turned on before a Datacolor program is
launched, you may receive an error message.
4. Depending on the model you are using, the LED lights on the status panel may
include the status of the following mechanisms:
− Aperture plate/zoom lens position
− UV filter status
− Specular port status
When the Ready light remains on, your instrument is ready to use.
5. Launch a Datacolor program.
6. Prepare to calibrate the instrument. You will need the black trap, the white
calibration tile and the green diagnostic tile.