Datalogic Dragon D131 - Dragon M131;STAR-Modem in Stand Alone Mode

DRAGON™ D131/M131
30
4.5.2 Dragon™ M131/STAR-Modem™ in Stand Alone Mode
To configure a Dragon™ M131 reader to communicate with STAR-Modem™ in
Stand Alone Mode, follow the procedure in par. 4.5 substituting steps 6 and 7 with
those below:
STAR-Modem™ Address
6.
ÌRSRÎ
Read the code above and the four-digit address of the STAR-Modem™.
7.
Exit and Save configuration
Ì$-?Î
END of procedure.
YOUR READER IS NOW READY TO READ BARCODES.
To change the defaults see par. 4.10.