Datalogic Dragon D131 - Using Multiple M-Series Readers with same Cradle

CONFIGURATION
29
Read the OM-30X0 restore default code:
9.
Restore OM-30X0 Default
Ì$+RX0$-qÎ
Go to par. 4.8 Interface Selection.
4.5.1 Using Multiple M-Series Readers With Same Cradle
If you want to use several M-Series readers with the same OM-30X0 cradle, you
must first Bind the cradle with one of the readers (see previously described
configuration procedure).
Successive readers
can be associated with the same cradle by following the
configuration procedure substituting the Bind command with Join (step 7).
7.
Join
Ì$+RN1$-NÎ
The green LED on the Dragon™ M131 will blink: the reader is ready to be
positioned onto the cradle. Complete step 8.
END of procedure.
CAUTION
All readers associated with the same cradle must have different
addresses.
YOUR READER IS NOW READY TO READ BARCODES.
To change the defaults see par. 4.10.