DRAGON™ D131/M131
34
Read the OM-3000 restore default code:
5.
Restore OM-3000 Default
Ì$+RX0$-qÎ
Read the desired Enable Network code.
Enable RS485 Master
6.
Ì$+RZ2$-ÇÎ
Enable RS485 Slave
Ì$+RZ1$-~Î
END of procedure.
For Host Master Network Layouts (see par. 3.2), The network configuration
parameters can be changed through STAR-Link™ software running on the PC.
Star-Link™ software can be downloaded for free from the web site:
www.datalogic.com.
For OM-3000 Master Network Layouts (see par. 3.2), The network configuration
parameters can be changed either through the Datalogic Aladdin™ configuration
software running on the PC or by reading the barcode selections in the Network
section of this manual starting on page 65. If using configuration barcodes, it is
advised to completely configure the cradles before reconfiguring the Dragon™ M131
reader (see below).
NOTE
After completing the OM-3000 cradle configuration and
connections in the network, you must reconfigure the
Dragon™ M131 reader using the STAR-System™ procedure in
par. 4.6.
To Next Page
Loading...
