EasyManuals Logo

Datalogic falcon x3+ User Manual

Datalogic falcon x3+
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #94 background imageLoading...
Page #94 background image
1 FALCON X3+
86
4
4.8.3 Updating the Firmware
After copying the firmware image to the host PC (see par. 4.10.1) and installing DFU
(see par. 4.8.2), you can upgrade the firmware on your Datalogic device.
The following steps require that you have already established an
ActiveSync or Windows Mobile Device Center connection between
the host computer and the Datalogic device
NOTE
1. Go to Start > Programs > Datalogic > DFU > Datalogic Firmware Utility.
2. Verify that ActiveSync is selected by clicking Communications >
WMDC/
ActiveSync.
3. Click browse (...) and navigate to the location where you saved the firmware
file for your terminal.
4. Select the current *.out file and click Open.
5. Click Update.
6. DFU will compare the selected firmware image with the firmware already
loaded on the device; if the image is compatible with the connected device,
DFU will proceed to update the firmware image on your device.
After the firmware of your device has been updated, DFU will automatically
perform a warm reset of the device.

Table of Contents

Other manuals for Datalogic falcon x3+

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datalogic falcon x3+ and is the answer not in the manual?

Datalogic falcon x3+ Specifications

General IconGeneral
Display diagonal3.5 \
Display resolution640 x 480 pixels
Display number of colors65536 colors
Flash memory1 GB
Internal memory0.256 GB
Internal memory typeRAM
Compatible memory cardsMicroSD (TransFlash), MicroSDHC
Processor familyPXA 310
Built-in processorPXA310
Processor frequency0.806 GHz
Processor manufacturerMarvell
GPS (satellite)No
Operating system installedWindows Embedded Handheld 6.5
Data networkNot supported
Wi-Fi standards802.11a, 802.11b, 802.11g
Bluetooth version2.1+EDR
Rear camera resolution (numeric)3.1 MP
USB 2.0 ports quantity1
Storage temperature (T-T)-30 - 70 °C
Operating temperature (T-T)-20 - 50 °C
Battery capacity5200 mAh
RFID reader-
Product colorBlack
Linear (1D) barcodes supportedGS1-128 (UCC/EAN-128), Intelligent Mail, PLANET, POSTNET, RM4SCC / KIX, U.P.C.
International Protection (IP) codeIP65
2D (matrix & stacked) barcodes supportedAztec Code, Data Matrix, MaxiCode, Micro QR Code, MicroPDF417, PDF417, QR Code
Weight and Dimensions IconWeight and Dimensions
Depth168 mm
Width88 mm
Height225 mm
Weight674 g

Related product manuals