Datalogic Gryphon GBT4400 User Manual

Setting Up the Reader
2Gryphon™ GBT4400
Setting Up the Reader
Follow the steps below to connect and get your reader up and
communicating with its host.
1. Configure the Base Station starting on this page.
2. Charge the Batteries (see page 14).
3. Link to the Base Station (see page 20).
4. Select the Interface Type (see page 21).
5. Configure the Reader starting on page 33 (optional,
depends on settings needed).
NOTE
According to recent modification of Regulation
for shipping Li-Ion based battery packs, the
products and their spare battery packs parts
are shipped with a very low residual charge
(low state of charge).
Hence the needs
* that a new product must be fully recharged
before starting to use it.
and
* that battery packs of the stocked products
GBT/GM44 and spare battery pack parts must
be periodically recharged : for instance by
using a BC40xx cradle powered up with a 12V
Datalogic AC/DC adapter (cod.8-0935) for at
least 30 minutes each 3 months.

Datalogic Gryphon GBT4400 Specifications

General

Connectivity	Bluetooth
IP Rating	IP52
Operating Temperature	0 to 50 °C / 32 to 122 °F
Storage Temperature	-20 to 70 °C / -4 to 158 °F
Dimensions	18.1 x 7.1 x 10.0 cm / 7.1 x 2.8 x 3.9 in
Scanner Type	2D Imager
Battery	Lithium-Ion
Drop Resistance	1.8 m (6 ft) to concrete
Light Source	Red LED
Image Sensor	CMOS
Decode Capabilities	1D, 2D, Postal Codes, Stacked Codes
Scan Rate	60 frames/sec
Interface	USB, RS-232, Keyboard Wedge
Power Supply	5 VDC +/- 10%
Humidity	5 to 95% non-condensing
Drop Specification	1.8 m (6 ft) to concrete