Connecting the Base Station
12 Gryphon™ GBT4400
Cleaning electrical contact surfaces
Regular cleaning of electrical contacts is needed to guarantee
a correct recharging of the battery. Both scanner and cradle
contacts should be cleaned.
In case spills, smudges or debris accumulate on the cradle
and/or the scanner, proper operation could be affected and a
periodical cleaning is recommended as follows.
Avoid the use of brushes or any other hard tool to remove
grime from electrical contacts, since these may damage or
scratch the contact’s plating.
Scanner Contacts
• Use a soft dry cloth to clean the contact area and the
plastic surface around the contacts.
• Be sure to remove dust, dirt and any cloth residue.
• If the level of grime is significant, it is suggested the
use of a soft white or pink pencil eraser to gently rub
the contacts. Motion can be along both the green and
yellow directions.
• Be sure to remove the rubber residuals by gently
blowing them off with clean compressed air.
CAUTION
Do not use abrasive or aggressive cleansing
agents or abrasive pads to clean scan windows,
contacts or plastics.
Do not spray or pour liquids directly onto the
unit. DO NOT use aerosols nor solvents.
Be sure to turn off power and unplug the device
from electrical outlet before cleaning.
Be sure to dry up the device before powering it
up.
Cleaner and liquids may be harsh on metal con-
tacts. They are recommended for use only on
enclosures.
DO NOT use solutions in their concentrated
form.
DO NOT use paper towels or rough cloths to
clean windows.
To Next Page
Loading...
