Datalogic Gryphon GBT4400 - Linking the Reader; Link Datalogic RF Devices to Base; Link Scanner to Bluetooth Adapter

Linking the Reader
20 Gryphon™ GBT4400
Linking the Reader
Link Datalogic RF Devices to Base
For RF devices, before configuring the interface it is necessary
to link the handheld with the base.
To link the handheld and the base, either press the trigger to
wake it, or simply mount into the base to wake up for opera-
tion. If the reader was previously linked to another base, you
must first scan the
Unlink bar code before re-linking to the
new base.
Link Scanner to Bluetooth Adapter
1. Install any drivers provided with the Bluetooth adapter.
2. Scan the
Enable RF Link to Server label below to make
the scanner visible to the host computer.
3. Use the host computer’s Bluetooth manager to “Dis-
cover new devices” and select "Datalogic Scanner." If
you receive an error message, it may be necessary to
disable security on the device.
4. Use an RS-232 terminal program to see incoming data
on the port designated by the computer's Bluetooth
manager.
NOTE
The Gryphon I GBT4400 can be set up to require
a PIN code when connecting. If you want to set
up a PIN, or when adding new equipment to a
system that uses a custom security PIN, please
see the PRG for information.
Unlink
Enable RF Link to Server