LED and Beeper Indications
Quick Reference Guide 43
LED and Beeper Indications
The reader’s beeper sounds and its LED illuminates to indi-
cate various functions or errors on the reader. An
optional“Green Spot” also performs useful functions. The fol-
lowing tables list these indications. One exception to the
behaviors listed in the tables is that the reader’s functions are
programmable, and so may or may not be turned on. For
example, certain indications such as the power-up beep can
be disabled using programming bar code labels.
a Except when in sleep mode or when a Good Read LED Duration other than 00 is selected
Indication Description LED Beeper
Power-up
Beep
The reader is in the
process of power-
ing-up.
N/A
Reader beeps four
times at highest
frequency and vol-
ume upon power-
up.
Good Read
Beep
A label has been
successfully
scanned by the
reader.
LED behavior for
this indication is
configurable via
the feature “Good
Read: When to
Indicate”
(see the PRG for
information.)
The reader will
beep once at cur-
rent frequency,
volume, mono/bi-
tonal setting and
duration upon a
successful label
scan.
ROM Failure
There is an error in
the reader's soft-
ware/programming
Flashes
Reader sounds
one error beep at
highest volume.
Limited Scan-
ning Label
Read
Indicates that a host
connection is not
established when
the IBM or USB
interface is enabled.
N/A
Reader 'chirps' six
times at the high-
est frequency and
current volume.
Reader Active
Mode
The reader is active
and ready to scan.
The LED is lit
steadily
a
N/A
Reader
Disabled
The reader has been
disabled by the
host.
The LED blinks
continuously
N/A
Green Spot
a
flashes
momentarily
Upon successful
read of a label, the
software shall turn
the green spot on
for the time speci-
fied by the config-
ured value.
N/A N/A
Image
Capture
When ready to cap-
ture image
Blue light flashes
2 times when
updating
N/A
To Next Page
Loading...
