Datalogic Gryphon GBT4400 - Page 52

LED and Beeper Indications
44 Gryphon™ GBT4400
Programming Mode - The following indications ONLY occur when
the reader is in Programming Mode.
INDICATION DESCRIPTION LED BEEPER
Label Programming
Mode Entry
A valid programming
label has been
scanned.
LED blinks
continu-
ously
Reader sounds
four low fre-
quency beeps.
Label Programming
Mode Rejection of
Label
A label has been
rejected.
N/A
Reader sounds
three times at
lowest frequency
and current vol-
ume.
Label Programming
Mode Acceptance of
Partial Label
In cases where mul-
tiple labels must be
scanned to program
one feature, this
indication acknowl-
edges each portion
as it is successfully
scanned.
N/A
Reader sounds
one short beep at
highest fre-
quency and cur-
rent volume.
Label Programming
Mode Acceptance of
Programming
Configuration
option(s) have been
successfully pro-
grammed via labels
and the reader has
exited Programming
Mode.
N/A
Reader sounds
one high fre-
quency beep and
4 low frequency
beeps followed by
reset beeps.
Label Programming
Mode Cancel Item
Entry
Cancel label has been
scanned.
N/A
Reader sounds
two times at low
frequency and
current volume.