Programming
6Gryphon™ GFS4400
Programming
The reader is factory-configured with a set of standard default fea-
tures. After scanning the interface bar code from the Interfaces sec-
tion, you can select other options and customize your reader through
use of the programming bar codes available in the Gryphon I
GFS4400 Product Reference Guide (PRG).
Programming can also be performed using the Datalogic Aladdin™
Configuration application, which is downloadable from the Datalogic
website listed on the back cover of this manual. This multi-platform
utility program allows device configuration using a PC. It communi-
cates with the device using a serial or USB cable and can also create
configuration barcodes to print.
Using Programming Bar Codes
This manual contains bar codes which allow you to reconfigure your
reader. Some programming bar code labels, like "Reset Default Set-
tings" on page 7, require only the scan of that single label to enact the
change.
Other bar codes require the reader to be placed in Programming
Mode prior to scanning them. Scan an
ENTER/EXIT bar code once to enter Programming Mode; scan the
desired parameter settings; scan the ENTER/EXIT bar code again to
accept your changes, which exits Programming Mode and returns the
reader to normal operation.
Configure Other Settings
Additional programming bar codes are available in the PRG to allow
for customizing programming features. If your installation requires
different programming than the standard factory default settings,
refer to the PRG.
To Next Page
Loading...
