Datalogic Magellan 2300HS Product Reference Guide

Problem Isolation
4-2 Magellan
TM
2200VS and 2300HS
Diagnostic Tests
See Chapter 3, Scanner Diagnostic Mode for details about running diag-
nostic tests for the scanner. If a problem is discovered during diagnostics,
the scanner will provide feedback about the source of the problem. The
remainder of this section describes these failure indications and includes
troubleshooting flowcharts to help isolate the problem.
Diagnostic Procedures
Your Point-Of-Sale (POS) system may contain many components that
operate as a system. Since almost all scanner problems are caused by either
the scanner, POS terminal or communication links between them, trou-
bleshooting flowcharts provided in this chapter focus on these compo-
nents. Additionally, the AC/DC Power Supply and scanner cables are
potential problems addressed.
The flowcharts provided here walk you through a diagnostic process that
will isolate the failed component and instruct as to the corrective action
required. Since internal scanner components cannot be replaced by an
operator or installer, most functional errors will require the assistance of a
trained technical support person. However, if the problem is caused by
faulty cable, or power supply, you can fix the problem by replacing the
defective component and complete the installation.

Datalogic Magellan 2300HS Specifications

General

Scanner type	1D
Decoding standards	GS1 DataBar
Input voltage	90 - 265 V
Power requirements	47-63 Hz
Power consumption (standby)	2.5 W
Dimensions (WxDxH)	152 x 152 x 86 mm
Certification	RoHS
Product color	Gray
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Weight	1100 g