Datalogic Magellan 2300HS Product Reference Guide

LED and Beeper Indicators
Product Reference Guide 5-9
LED and Beeper Indicators
The scanner provides a set of indicators that verify/announce the various
scanner functions.
If You Make a Mistake...
If, during a programming session, you find that you are unsure of the
scanner’s settings or wish to reset the scanner’s configuration, use the
Return to Factory Settings label below to return the scanner’s configura-
tion to the factory settings. Scanning this label will also reset any changes
made during previous programming sessions.
Return to Factory Settings
Scan this bar code to return the scanner to the default settings configured
at the factory. This bar code is typically used to return the scanner to a
“known” operating state when the present programming status is not
known, faulty, or suspect.
The process of Returning to Factory Settings requires two steps:
1. Scan the Return to Factory Settings bar code.
2. Set your required interface type using the instructions in Interface
Related Features on page 5-37.
Step 2 is important because the Return to Factory Setting bar code may
alos change your scanner’s interface type.
CAUTION
Use this bar code with caution, since it will reset ALL features that
may have been programmed since the scanner’s installation.
NOTE
DO NOT scan the SWITCH bar code before and after scanning this
bar code.

Datalogic Magellan 2300HS Specifications

General

Scanner type	1D
Decoding standards	GS1 DataBar
Input voltage	90 - 265 V
Power requirements	47-63 Hz
Power consumption (standby)	2.5 W
Dimensions (WxDxH)	152 x 152 x 86 mm
Certification	RoHS
Product color	Gray
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	10 - 40 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Weight	1100 g