22
QuickScan 6000/6000 Plus
Intercharacter Delay
Intercharacter Delay refers to the pause, if any, between each character
before it is sent to the host. This time delay is used to control the flow of
data from the scanner, but it should not be required for most applications.
Use these labels to select the desired Intercharacter Delay.
SET ----------------------------------------------
= NONE ----------------------------
= 10 MILLISECONDS ----------------
= 20 MILLISECONDS ----------------
= 30 MILLISECONDS ----------------
= 40 MILLISECONDS ----------------
= 50 MILLISECONDS ----------------
= 60 MILLISECONDS ----------------
= 70 MILLISECONDS ----------------
= 80 MILLISECONDS ----------------
I
NTERCHARACTER
D
ELAY
To Next Page
Loading...
