44
QuickScan 6000/6000 Plus
Disabling Label I.D. for a Specific Symbology
This procedure is the same as setting a single character symbology
identifier, except you should scan two zeros and the One Character Only
labels before scanning the END label.
Symbology Specific Label Identifiers Characters
Use the labels on this page to change or modify symbology identifiers.
0 ------------------------------------
1 ------------------------------------
2 ------------------------------------
3 ------------------------------------
4 ------------------------------------
5 ------------------------------------
6 ------------------------------------
7 ------------------------------------
8 ------------------------------------
9 ------------------------------------
To Next Page
Loading...
