Datalogic QuickScan QM2430-BK-433K1 User Manual

Data Format Enter/Exit Programming Mode
Product Reference Guide 59
Individually Set Label ID
This feature configures a Label ID individually for a single symbology. To set, first define
whether you want it as a prefix or suffix by scanning a label below. Then turn to Label ID Sym-
bology Selection − 1D Sy
m
bologies, starting on page 60 to select the symbology you want to
set, followed by up to 3 characters from the ASCII Chart at the back
of this manual. See "Label
ID: Set Individually Per Symbology" on page 250 for detailed instructions on
setting this feature.
Label ID Control
This option controls whether a Label ID is disabled, or sent as a prefix or suffix for a given sym-
bology type.
DEFAULT
$CIDCO00(CR)
Label ID Transmission = Disable
$CIDCO01(CR)
Label ID Transmission = Enable as Prefix
$CIDCO02(CR)
Label ID Transmission = Enable as Suffix

Datalogic QuickScan QM2430-BK-433K1 Specifications

General

Brand	Datalogic
Model	QuickScan QM2430-BK-433K1
Category	Barcode Reader
Language	English