Enter/Exit Programming Mode Scanning Features
82 QuickScan™ I QD24XX/QBT24XX/QM24XX
Aiming Duration Timer
Specifies the frame of time the aiming pointer remains on after decoding a label, when in trig-
ger single mode.The range for this setting is from 1 to 255 seconds in 1-second increments.
See page 257 in “References” for a description of this feature.
Aiming Off After Decoding
Set Aiming Duration Timer
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left followed
by the digits from the Alphanumeric characters in
Appendix D, Keypad
representing your desired
character(s). End by scanning the ENTER/EXIT bar code.
Make a mistake? Scan the CANCEL bar code to abort and
not save
t
he entry string. You can then start again at the
beginning.
CANCEL
To Next Page
Loading...
Need help?
General
