Datalogic Applications
User’s Manual 93
DXU Application Controls
Available Device List and Configuration
The Available Devices list displays devices which are either currently
connected, have been connected since launching DXU, or were
manually connected at some time in the past. You can refresh the
view to automatically show devices or hide devices which connect
while you work on another device. In general, they should appear
automatically as they connect.
By default, No Devices Available will display when no devices
announce themselves to DXU either when they connect via USB or
when they connect over a network. Simply connecting the Skorpio
X4 to a network, even on the same subnet as the PC running DXU,
will not automatically display as being available. The device must try
to connect to DXU, which sends an announcement packet to DXU.
This can be done by scanning Scan2Deploy barcode labels. However,
connecting a device to the PC running DXU via USB will
automatically display it in DXU. You will need to enter the DXU
control panel on the device and press the Pair button in order to
Automatic Discovery of Devices to properly function.
To configure a connected device, you simply click its button under
Available Devices to load its configuration into DXU.
To Next Page
Loading...
Need help?
General