Getting Started
User’s Manual 33
WEC7 Touch Screen Calibration
At the very first Skorpio X4 startup, after any cold boot (if the user
skipped stylus calibration earlier) or following a clean boot, a
Welcome Wizard with Stylus Calibration comes up.
Also, you might need to recalibrate the touch screen (i.e. when you
attempt to select an item with the stylus, another item is
erroneously selected).
To recalibrate the touch screen, following the steps below:
1. Tap Start > Settings >Control Panel. Double tap the Stylus icon
to open the Stylus Properties window:
To Next Page
Loading...
Need help?
General