Maintenance
212 Skorpio™ X4
If the plastic areas are very dirty use only a cloth dampened with
water.
Cleaning the Dock Contacts
1. Remove the power cable before cleaning the contacts.
2. Use a soft dry cloth as suggested above. If the product is very
dirty, moisten the cloth in a non-aggressive cleaning solution or
diluted isopropyl alcohol solution (20% maximum).
3. Gently rub the cloth back and forth ONLY along the contacts,
following the directions indicated by the red arrows. Use care not
to leave any cloth residue.
4. Use a dry cloth to remove any dirt near the contacts area and to
clean the plastic parts. If the plastic parts of the equipment are
very dirty, slightly dampen the cloth with only water.
5. Repeat steps 2, 3 and 4 using a clean dry cloth.
CAUTION
Do not use abrasive or aggressive cleaning agents or
abrasive pads to clean electric contacts, scan windows
or plastics.
To Next Page
Loading...
Need help?
General