Datamax M-Class Mark II M-4206 User Manual

M-4206 5
2.0 Before Using the Printer
Removing the Packaging
Inspect the shipping container(s) for damage; if damage is evident notify the shipping company to report the nature and
extent of the damage.
The printer is carefully packaged to avoid any damage during transit. In order to operate the printer you will need to
remove the packaging materials (i.e., tape and foam) that were placed in the printer for shipment. Complete the following
steps prior to connecting power or attempting to load media.
¾ Ensure that the arrow on the box is pointing up, and then open the box.
¾ Remove the top piece of packing foam.
¾ Lift the printer from the box.
¾ Remove the printer from the plastic bag.
¾ Remove any tape or additional packing foam from the inside of the printer.
; Note: It is a good idea to save all packaging materials in the event that shipping the printer is ever required.

Datamax M-Class Mark II M-4206 Specifications

General

Print Resolution	203 dpi
Print Method	Thermal Transfer and Direct Thermal
Max Print Width	4.25 inches
Max Print Speed	6 ips
Memory	8 MB Flash
Interfaces	Serial, Parallel, USB
Media Sensor	Reflective and Transmissive
Media Types	Labels, Tags
Label Roll Diameter	8 inches
Label Thickness	0.0025 to 0.01 inches
Maximum Print Length	99 inches