Datamax M-Class Mark II M-4206 User Manual

36 M-4206
4.8.3 Hex Dump Label
The Hex Dump Label is a useful tool in the diagnosis of problems including communications handshaking and DPL syntax
errors. To generate a Hex Dump Label the printer enters into Hex Dump Mode. In this mode, all data sent to the printer
will be immediately output in hexadecimal code, along with the printable ASCII equivalents. To decode this information,
the Programmer’s Manual is an essential reference. As a final note, many software programs use bit mapping to construct
the label, making diagnosis of this data difficult. Contact Datamax Technical Support with any questions.
To print the Hex Dump Label:
With the printer on, loaded with media (at least 4 inches wide) and ribbon (if printing with thermal transfer media), press
and hold the
FEED
button while turning the printer on. Continue holding the
FEED
button until the
STOP
light turns
off. Now, all data received by the printer will be output in hexadecimal code, as shown below.
To exit the Hex Dump Mode:
Turn the printer off.

Datamax M-Class Mark II M-4206 Specifications

General

Brand	Datamax
Model	M-Class Mark II M-4206
Category	Printer
Language	English