Datamax M-Class Mark II User Manual (English)

To Next Page

To Previous Page

Chapter 4 – Menu System 37

SET FACTORY

DEFAULTS

Returns the printer settings to the factory-programmed values (except CUSTOM

ADJUSTMENTS and calibrations); or, if selected, to the Factory Setting File, where

selecting YES at the prompt causes the configuration to be restored.

FORMAT

ATTRIBUTES

Defines the manner in which overlapping text and graphics appear when printed,

where:

TRANSPARENT Intersecting text, images, and bar codes will be printed, for example:

XOR Intersecting text, images, and bar codes will not be printed, for example:

(Default Setting)

OPAQUE Intersecting text, images, and bar codes will be printed by obliterating those

formatted first, for example:

LABEL ROTATION Allows the label format to be rotated 180 degrees before printing, where:

ENABLED Flips the format.

DISABLED Does not flip the format. (Default Setting)

IMAGING MODE Determines the process used to format labels, where:

MULTIPLE LABEL Images multiple labels as memory permits to achieve the fastest throughput. If

time-stamping labels, however, the indicated time will reflect the moment of

imaging rather than the actual print time. (Default Setting)

SINGLE LABEL Images the next label only after the previous label has been printed, providing the

most accurate time-stamps but at a slower throughput rate.

PAUSE MODE Allows for controlled interactive printing, where:

ENABLED Requires you to press the PAUSE Key to print each label.

DISABLED Labels are printed without pausing. (Default Setting)

PEEL MODE Allows the printer to wait until the Start of Print signal is received (via the optional

GPIO Port) to feed a label, where:

ENABLED Inhibits the feed function until the Start of Print signal is received.

DISABLED Feeds the label regardless of the Start of Print signal. (Default Setting)

SECURITY Allows all or part of the User Interface to be password-protected and for that

password to be modified:

SELECT

SECURITY

Allows password to be set for specific User Interface areas, where:

DISABLED No password is required for menu access. (Default Setting)

SECURE MENU Sets a password requirement for User and Advanced menu entry.

MENU AND

TEST

Sets a password requirement for all menu entries.

ADVANCED

Sets a password requirement for Advanced menu entry. (After enabling this

selection, make it effective by returning the Menu Mode to the User setting; see

above.)

MODIFY

PASSWORD

Modifies the four-digit password required when security is enabled. For

modification, the code must be reentered when prompted to confirm.



To be activated, the password must initially be set to a value other than the default setting

(0000).

Other manuals for Datamax M-Class Mark II

Maintenance Manual94 pages

Manual10 pages

Quick Start Guide8 pages

Need help?

Do you have a question about the Datamax M-Class Mark II and is the answer not in the manual?

Datamax M-Class Mark II Specifications

General

Media Sensor	Adjustable reflective and transmissive sensors
Print Method	Thermal Transfer
Print Resolution	203 dpi
Memory	8 MB Flash, 16 MB SDRAM
Interface Options	USB, Serial, Ethernet, Parallel
Media Type	Roll-fed, die-cut, continuous, fan-fold, tags, ticket stock
Media Width	1.0 in (25.4 mm) to 4.65 in (118 mm)
Media Thickness	0.0025 in (0.0635 mm) to 0.010 in (0.254 mm)
Media Roll Diameter	8 inches (203 mm) max
Ribbon Width	1 to 4.33 inches (25.4 to 110 mm)
Ribbon Length	1968 ft (600 m)
Ribbon Core	1 inch (25.4 mm)
Label Width Range	1.0 in (25.4 mm) to 4.65 in (118 mm)
Label Length Range	0.25 to 39 inches (6.35 to 991 mm)