S-Class 5
Getting Started
2.0 Unpacking
Inspect the shipping container(s) for damage; if evident, notify the
shipping carrier to report the nature and extent of the damage before
proceeding.
The printer is carefully packaged to avoid any damage during transit. In
order to operate the printer, you will need to remove the packaging
materials placed there for shipment. Complete the following steps prior
to connecting power or attempting to load ticket stock.
Carefully open the shipping container, remove the printer, and place
it on a level, stable surface.
CAUTION
Do not rest SV models “end-down” on any surface. Damage
to the printer’s connectors may occur.
Remove the printer from the plastic shipping bag.
Carefully remove the tape that extends
over the Printhead Latch.
(On SV Models also remove the tape
that covers the interface connectors.)
Note: Save all packaging in the event that shipment is ever required.
To Next Page
Loading...
