36 S-Class
4.3 Operational Database Modification
The operational configuration of the printer, including the Parser Mode
and other parameters, can be changed via the front panel, as follows:
If on-line, press the PAUSE button to place the printer off-line.
Press and hold the F2 button until the On-Line Indicator is lit
(approximately six seconds) then release the button. The printer is
ready for database changes:
Press the F1 button to advance to the next setting of the
current item, print the selection, and present it for
acceptance.
Press the F2 button to accept the presented item and
value for use then print and present the next item, or
press and hold the F2 button (until the On-Line Indicator
is lit) to cause a Warm Reset, apply the new settings, and
place the printer on-line.
Press the F3 button to return to the previous setting for
the current item, print the selection, and present it for
acceptance.
The following pages contain listings of the settings and values that are
accessible and modifiable through this method. Section 4.3.1 contains a
step-by-step example of a parameter modification.
To Next Page
Loading...
