10 S-Class
3.2 Loading Ticket Stock
The procedure to load the printer differs depending upon the model,
options, and stock type being used. These differences are detailed below.
3.2.1 ST Models
Note: If your printer is equipped with the Roll Hanger option but you want to
use an internal fan-fold ticket source instead, the Roll Hanger must
be removed. Remove the Roll Hanger by turning it counter-clockwise
to unscrew it from the centerplate of the printer.
To load fanfold ticket stock into a table-top printer proceed as follows:
Plug in and turn ‘On’ the printer.
Insert the Key into the lock and turn it, as shown, to unlock the
Access Cover.
Raise the Access Cover (or, for convenience, the cover may be
removed by sliding it forward and then raising it up and off the
hinges).
Perform this step according to the printer’s Media Sensor option and
the type of ticket stock being used:
To Next Page
Loading...
