Need help?Do you have a question about the dbx DriveRack 482 and is the answer not in the manual?
General| Input Channels | 2 |
|---|---|
| Sample Rate | 48kHz |
| Crossover | Yes |
| Compressor | Yes |
| Limiter | Yes |
| Noise Gate | Yes |
| Input Connectors | XLR |
| Output Connectors | XLR |
| Frequency Response | 20Hz - 20kHz, +/- 0.5dB |
| Dynamic Range | >110dB |
| Power Supply | 90-240 VAC, 50/60 Hz |
| A/D Converters | 24-bit |
| D/A Converters | 24-bit |
| EQ | Parametric |
| Delay | Yes |
| Output Impedance | 120Ω |
| Dimensions | 19" |
| Weight | 6.5 lbs |
| THD+N | <0.003% @ +4dBu, 1kHz |
| THD + Noise | <0.003% @ +4 dBu, 1 kHz |
Provides essential safety warnings regarding operation, ventilation, heat sources, and accessories.
Details proper electrical connections, earthing, and risks associated with defeated ground connections.
Warns about explosion danger from incorrect lithium battery replacement and provides handling instructions.
Provides contact details for technical support and service inquiries.
Explains the core functionality and features of the DriveRack system models.
Details the product warranty terms, limitations, and validation process.
Details physical connections for models 480, 481, and 482 on rear and front panels.
Explains fundamental navigation and editing modes using buttons and parameter knobs.
Guides on navigating EQ, Crossover, RTA, Delay, Dynamics, Other, and Utility sections.
Details input routing options and mixer module parameters.
Describes parameters for graphic EQ, notch filters, delay, and crossovers before the main crossover.
Details parameters for post-crossover EQ, compressor/limiter, and speaker alignment delay.
Explains procedures for saving edited program and configuration changes.
Covers setting network IDs, security levels, and passwords for system access.
Details program lists, change modes, contrast, PC comm, MIDI, SysEx, and power-up settings.
Provides an overview, specs, applications, and installation guides for network setup.
Explains master/slave assignments, redundancy features, and troubleshooting network issues.
Guides on installing and operating the PC graphical user interface for system control.
Details the rear and front panel connections for the 480R and 480P units.
Explains how to use the RTA, Hot Keys, and control slave devices with the 480R.
Provides suggested installation applications for FOH, Bi-Amp, Monitor EQ, and Crossover setups.
Details SysEx message format, procedures, flash downloads, and program list management.
Explains gain jumper settings and provides input/output signal flow diagrams.
Illustrates various crossover filter configurations and signal paths.
To Next Page
