31
CLEANING THE GRILL BURNERS
Grill burners should be removed regularly for cleaning and to check for blockages from
food residue and insects. Always turn off gas supply before removing and cleaning burners.
1. Remove grates and
radiant trays. Use a flathead
screwdriver to loosen clamps,
then carefully lift burner up and
out of grill.
Shake gently to remove debris.
Clean exterior with a grill brush.
2. Use a flashlight to check
if the burner inlet is blocked.
If so, use a safety pin or
straightened paper clip to
unblock the inlet and the holes
along the burner tube.
You can also unblock the gas
jet inside the front of the grill
if required.
3. Refit burner so the inlet is
centered on the gas jet, then
lower burner onto mounts
at rear. Ensure it is level and
secure.
Take care not to damage
ignitor.
Burners must be properly
located to ensure safe
operation.
To Next Page
Loading...
Need help?
General
