Changing the upsampling mode
You can select between two processing options when receiving PCM data. The best
upsampling mode is a personal choice.
1. Tap .
2. Tap to select Processing.
3. Tap .
4. Tap to select Upsampling.
5. Tap to change the upsampling mode.
DSD. The unit adds a DSD upsampling step before the end of the PCM oversampling
process.
DXD. The unit uses its standard PCM oversampling process for PCM data.
Changing the absolute phase of analogue outputs
When listening to music, if the character of the instruments sounds wrong then it may be
because the track was recorded with both channels phase-inverted. You can correct the
absolute phase of the outputs.
1. Tap .
2. Tap to select Processing.
3. Tap .
4. Tap to select Phase.
5. Tap to change between normal phase and inverted phase .
This setting is reset when you next switch the unit on.
Setting the clocking sync mode
You can change the clocking sync mode for the current input. The sync mode setting is stored
separately for each input.
1. Tap .
2. Tap to select Device Settings.
3. Tap .
4. Tap to change the clocking sync mode.
Settings
LINA Network DAC User Guide
35
To Next Page
Loading...
