DCS LINA - Turning Off the Display; Changing the Display Brightness; Resetting to Factory Conditions

38
Changing the line output level
The line output setting sets the maximum output level to suit your integrated amplifier or
preamplifier.
1. Tap .
2. Tap to select Device Settings.
3. Tap .
4. Tap to select Line Output.
5. Tap to change between 2V or 6V.
Turning off the display
When the display setting is set to off and you close the menu, the display turns off after a few
seconds. You can then tap any button to turn on the display briefly. The display stays on
while the menu is open.
1. Tap .
2. Tap to select Device Settings.
3. Tap .
4. Tap to select Display.
5. Tap to change the display setting.
Display is on.
Display is set to turn off when you close the menu.
Changing the display brightness
You can change the display brightness.
1. Tap .
2. Tap to select Device Settings.
3. Tap .
4. Tap to select Brightness.
5. Tap .
6. Tap or to change the display brightness.
Resetting to factory conditions
You can reset the settings to factory conditions.
1. Tap .
2. Tap to select Device Settings.
3. Tap .
Settings
LINA Network DAC User Guide