DCS LINA - Testing for Swapped Channels; Conditioning the Unit

4. Tap to select Factory Reset.
5. Tap to reset to factory conditions.
The default settings are below.
Setting Default value
Source NETWORK
Crossfeed Off
Filter Filter 1 for all sample rates
DSD Filter Filter 1
Upsampling DXD
Phase Normal
Sync Mode Word Clock Auto for Network and USB
Audio for AES / SPDIF
Dual AES Auto
USB Class Class2
Buffer Off
Line Output 2V
Display On
Brightness 10
Testing for swapped channels
You can test the system for swapped channels.
1. Tap .
2. Tap to select Channel Check.
3. Tap .
4. Tap to start the test.
The unit outputs a tone on the left channel and then the right channel. If what you
hear does not match what is shown on the display, check the connections and other
equipment for swapped channels.
Conditioning the unit
You can run a procedure to condition the unit. The system outputs modulated pink noise that
increases and decreases.
NOTICE
Conditioning the unit at high volumes can damage amplifiers and loudspeakers. Before
conditioning the unit, reduce the volume to a low level. dCS is not liable for any damage to
equipment due to incorrect use of the conditioning feature.
Settings
LINA Network DAC User Guide
39