rev1 ā Dec 2013 www.digitalcomtech.com 27
Syrus commands
DA - Destination Address
Qualifiers: Q, S, R.
A Destination Address is an association of Destination Points. These allows an event
defined with the ED message to be routed to multiple receivers at the same time by
selecting the Destination Address (or group) that holds all of the desired
destinations (IP-types, Telephones, Serial Port). A Destination Address is not the
actual IP address or SMS telephone of the receivers. The message has the following
format:
A;PBB[,PBB,...,PBB:PBB,...]
o A is the Destination Address' index. Its range goes from 0 to 9. Remember that a
Destination Address is a group or an association of Destination Points. A
Destination Point (see XADP message) is the actual IP address or telephone of a
destination.
o B holds a Destination Point's index. You can select multiple Destination Points by
separating them with a ','.
Examples:
To create Destination Address 5 as an association of Destination Points 2, 3, 10 and
15 (15 is the unit's serial port):
>SDA5;P02,P03,P10,P15<
To create Destination Address 0 with only one Destination Point, for example the
unit's serial port:
>SDA0;P15<
To Next Page
Loading...