rev1 – Dec 2013 www.digitalcomtech.com 50
Error List
00 - Unrecognized command.
01 - Internal error. Please verify the syntax of the Configuration Command and try
again.
02 - The message is not delimited by > and/or <
03 - ID miss match on incoming post fix ";ID="
06 - Not a valid set message.
07 - Incorrect or missing parameter. Please verify the syntax of the Configuration
Command and try again.
09 - Queries resulting on multiple answers are not supported over the air.
11 - Incorrect ACT, XCT or SMS Alias definition. See ED message.
12 - Destination point is already set. You can consult the destination points configured
with the XADP command.
13 - Error while consulting the IMSI or SIM Card ID. Please verify that the SIM card is
correctly installed and try again.
15 - Change state operation failed. Internal Error.
17 - APN or network problem while trying to run a firmware upgrade over the air.
Please verify the communications state using the XANS command.
19 - Incorrect index.
24 - Invalid characters on string parameter.
25 - Invalid vehicle ID. See the ID message.
36 - Signal sense (+ or -) missing, see ED message.
37 - Non-existent signal or missing operator on event definition, see ED message.
40 - The signal cannot be changed by the user. See the SS message.
42 - Invalid signal index. See the Signal List section.
57 - Could not delete the photos folder because a photo is in use.
59 - Invalid Range or Value.
60 - IP-type destination supplied with no port. See the XADP message.
61 - Telephone-type destination supplied can not include port parameter. See
the XADP message.
62 - Functionality not available on this version.
69 - Exceeded command length.
76 - Invalid counter operation. See the GC message.
78 - Counter operation failed.
96 - Internal flash memory error. Cannot save on flash.
99 - GPS data temporarily unavailable.
To Next Page
Loading...