rev1 – Dec 2013 www.digitalcomtech.com 46
XAID - IMEI as ID
Qualifiers: Q, S, R.
This message tells the unit whether to use or not its IMEI as ID. When changing this
parameter, it is necessary to reset the unit using the RT command in order to
reestablish the current connections to any Destination Point using the ID
setting. The default is to use the IMEI. The message has the following format:
A
o A: Flag:
1: Set the unit's ID with the IMEI. This is the default value.
0: Set the unit's ID to the value set by the user with the ID message.
Please refer to the ID and XAIM messages, which are closely related to this message.
XAIM - IMEI Consult
Qualifiers: Q, R.
This message is used to consult the unit's IMEI (International Mobile Equipment
Identity) The message has the following format:
AAAAAAAAAAAAAAB
o AAAAAAAAAAAAAA: Unit's IMEI.
o B: IMEI's Checksum.
Please refer to the ID and XAID messages, which are closely related to this message.
To Next Page
Loading...