DCT Syrus - ID - Unit Identification Setup

To Next Page

To Previous Page

rev1 – Dec 2013 www.digitalcomtech.com 34

ID - Identification

Qualifiers: Q, S, R.

This message is used to set/query unit's ID. When changing the ID it is necessary

to reset the unit using the RT command in order to reestablish the current

connections to any Destination Point using the new ID. The message has the

following format:

A[AAA...]

o A[AAA...]: Identification code assigned to the vehicle. This parameter is alpha-

numeric and up to 10 characters long. The only forbidden characters are ">", "<"

and ";" . The factory default is 0000.

Please refer to the XAID message, which are closely related to this message.

Examples:

To set the unit's ID:

>SIDTestUnit<